mirror of
https://gitlab.com/buildroot.org/buildroot.git
synced 2026-09-10 08:14:09 -09:00
d74a5a218f
This patch adds support for Xilinx Versal VEK280 Evaluation Kit.
VEK280 features can be found here:
https://www.xilinx.com/products/boards-and-kits/vek280.html
The VEK280 requires a patch for the memory node in the dts file because it is
not currently correct. This patch has been applied to the linux-xlnx repo and
will be included in the 2024.2 release.
Upstream: 3c7a97d99b
Signed-off-by: Neal Frager <neal.frager@amd.com>
Reviewed-by: Brandon Maier <brandon.maier@collins.com>
Reviewed-by: Luca Ceresoli <luca.ceresoli@bootlin.com>
[Julien: regenerated defconfig with savedefconfig for config ordering
and kept BR2_TARGET_XILINX_PREBUILT_VERSION]
Signed-off-by: Julien Olivain <ju.o@free.fr>
This document describes the Buildroot support for the following
Xilinx Versal boards:
******************************************
Supported Versal Boards:
Xilinx VCK190 board
Xilinx VEK280 board
Xilinx VPK180 board
******************************************
Evaluation board features can be found here with the links below.
VCK190:
https://www.xilinx.com/products/boards-and-kits/vck190.html
VEK280:
https://www.xilinx.com/products/boards-and-kits/vek280.html
VPK180:
https://www.xilinx.com/products/boards-and-kits/vpk180.html
How to build it
===============
Configure Buildroot:
$ make versal_vck190_defconfig
Compile everything and build the rootfs image:
$ make
Result of the build
-------------------
After building, you should get a tree like this:
output/images/
+-- boot.bin
+-- boot.vfat
+-- Image
+-- rootfs.ext2
+-- rootfs.ext4 -> rootfs.ext2
+-- sdcard.img
+-- system.dtb -> versal-vck190-rev1.1.dtb
`-- versal-vck190-rev1.1.dtb
How to write the SD card
========================
WARNING! This will destroy all the card content. Use with care!
The sdcard.img file is a complete bootable image ready to be written
on the boot medium. To install it, simply copy the image to an SD
card:
# dd if=output/images/sdcard.img of=/dev/sdX
Where 'sdX' is the device node of the SD.
Eject the SD card, insert it in the board, and power it up.